METAL HOSE & BELLOWS - Formely Hydraquip Metal Hose
PLUMBING & COOLING - Formely Hydraquip Braided Hose

Easy Plumbing Assemblies

Part Number:

Easy Plumbing Assemblies

DESIGN & MATERIAL CONSTRUCTION

Hose
Stainless Steel 316L
Braid
Stainless Steel AISI 304/304L
Temp

-269°C - +600°C 

Sizes

 ¼” NB – 16” NB

DESCRIPTION

HydraFlex Flexible Boiler Connector Hoses are primarily used to ease installation of temporary Boilers on site and eliminate the need for hard / fixed onsite piping. The Hose and Braid is manufactured in accordance with ISO 10380 : 2012. PED Classification depends on the Nominal Bore, Media conveyed and Maximum service pressure. The range listed below is categorised as SEP when the conveyed media is classified as a Non-Dangerous liquid (As defined in the Pressure Equipment Directive) up to the maximum working pressure detailed below.

APPLICATIONS

    • Building Services
    • HVAC-R Piping Lines
    • Pump Connections,
    • Vibration Producing Systems
    • Industrial Process &Applications
    • Steam connections
    • Chemical Process
    • Gas Connections
    • Ultra-High Vacuum applications
    • Exhaust systems

QUALITY & ASSOCIATED STANDARDS

All Hydraflex Metal Hoses are produced by fully penetrated TIG welding method to Hydraflex’s approved Weld procedures. Each and every Unit manufactured is 100% pressure tested to a minimum hydrostatic pressure test of 1.5 times of the design pressure. PED 2014/68/EU approval and material certificates to EN 10204 is available for all sizes.

- Hydraflex 316L Stainless steel Hose with Single
layer 304 wire overbraid
- Available as Bulk Hose / Braid on Drums / Coil
- Specific cut lengths available on request

HOSE DATA

TYPE 100 - STANDARD PITCH

TYPE 200 - STANDARD PITCH

TYPE 700 – HEAVY DUTY HOSE

TEMPERATURE / PRESSURE CORRECTION

REDUCTION COEFFICIENT OF PRESSURE AS A FUNCTION OF TEMPERATURE

END FITTINGS – HALF SECTION

PRESSURE DROP

The Pressure loss in corrugated hose is 100% higher than in new welded steel pipes. This means that in the case of corrugated hose an increase in diameter of approximately 15% is required to reduce the pressure loss to the
value of pressure loss in steel pipes. To utilise the chart...

  1. Identify the flow rate required on the base line (Horizontal Axis).
  2. Where the vertical line, that references to the nominal bore of the hose, intersects a horizontal line - Establish the pressure drop on the Vertical Axis. (Any data provided is for reference only. Please contact our Sales Team for additional information if required)

FLEXING INSTALLATIONS CHART

INSTALLATION GUIDE- DO’S & DON’T’S

LENGTH MEASURE POINTS

FURTHER INFORMATION 

For any more information that you may require then please contact one of our team. 

Northampton: 01604621964  Bolton: 01204529536  Rugby: 01604621964

Email: [email protected]

Technical Info

Spring lane, Northampton, NN1 2JW
United Kingdom

+44 (0)845 266 4334
[email protected]

DOWNLOAD TECHNICAL DATA SHEET

Start typing to see products you are looking for.